Signstek Updated Oscilloscope Kit DSO Shell with 2.4” TFT Digital Power Supply and BNC-Clip Cable

Price: $27.99
Product prices and availability are accurate as of 2020-12-13 17:37:38 UTC and are subject to change. Any price and availability information displayed on https://www.amazon.com/ at the time of purchase will apply to the purchase of this product.
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Manufacturer Description

Function:
-. Select sensitivity or vertical position. The selected parameter indicator will be highlighted.
-. Select timebase or horizontal position. The selected parameter indicator will be highlighted.
-. Select trigger mode, trigger level. Ad trigger edge. The selected parameter indicator will be highlighted.
-. Enter HOLD state (freeze waveform). Press it again will de-freeze.
-. Adjust the parameter selected (highlighted). Short press toggles Fast Adjustment mode.
-. Set couple to DC, AC, or GND. When GND is selected the scope input is isolated from inpur signal and connected to ground (0V input).

Specification:
Max Realtime Sample rate: 1MSa/s
Analog Bandwidth: 0--200KHz
Sensitivity Range: 5mV/div - 20V/div
Max Input Voltage: 50Vpk (1X probe)
Input Impedance: 1M ohm/20pF
Resolution: 12bit
Record Length: 1024 points
Time Base Range: 500s/Div - 10us/Div
Trigger Modes: Auto, Normal, and Single
Trigger Position: Center of buffer
Power Supply: 9VDC (0 - 10V)
Current Consumption: ~120mA@9V
Dimension: 105 x 75 x 22mm
Weight: 100g (without probe and PS)

Package includes:
1 x DSO Shell Oscilloscope
1 x BNC-clip Cable
1 x Adaptor
1 x User Manual

Product Features

Update Oscilloscope Kit: It reaches 5mV/div -- 20V/div. Also, this updated version can be handheld. Integrated: Display and MCU are mounted on the same board (mainboard) to avoid using inter-board pin-headers. Measurements including Vmas, Vmin, Vavr, Vpp, Vrms. Freq., Cycle, Pulse width, and Duty cycle. Save & Recalled: The currently displayed waveform is saved to EEPROM. The existing data in EEPROM will be over-written. Recalled waveform is always displayed in Hold state. Easy to use: It has been added the rotary encoder, makes parameter adjustment more quicker and easier