Overview:
This mini oscilloscope is designed for electronic hobbyists to learn about electronics, soldering, programming and STM32. It contains main controller board, TFT LCD and other electronic components to DIY a functional mini digital oscilloscope.
Connection:
Power Supply: DC 8V-10V, recommend DC 9V, no more than 10V
Probe: connect the probe to BNC
Notice: This oscilloscope requires DC 9V 200mA power supply (no more than 10V)
Specification:
 Model: DSO320
 Input impedance: 1M?
 Analog Bandwidth: 0 - 200 KHz
 Maximum input voltage: 50Vpp (1: 1 probe), 400Vpp (10: 1 probe)
 Maximum real-time sampling rate: 1Msps
 Comes 1Hz /3.3V square wave test signal source
 Accuracy: 12Bit
 Sampling buffer depth: 1024 bytes
 Vertical Sensitivity: 5mV/Div - 20V/Div
 Adjustable vertical displacement, and with instructions
 Coupling modes: DC / AC / GND
 The horizontal time base range: 10?s / Div - 50s / Div (1-2-5 progressive manner)
 With automatic, regular and one-shot mode, easy to capture the moment waveform
 Available rising or falling edge trigger
 Adjustable trigger level position, and with instructions
 Observable previous trigger waveform (negative delay)
 Can freeze at any time waveform display (HOLD function)
Packing List:
1x DSO320 Oscilloscope DIY Kit
1x Probe
1x Power Supply
Download:
http://s3.amazonaws.com/s3.image.smart/download/101-10-186/101-10-186-User_Manual_EN.pdf
Use STM32 Chip: It runs faster than DSO138 and a good handle of data.
Pre-programmed: The controller board is programmed and tested before leaving factory. It is high quality and safe to use.
Full of Fun: It is a DIY kit and fun to make your own oscilloscope. Especially suitable for who are interested in soldering and STM32.
With Cool Black Case: Unlike DSO138, SainSmart DSO320 is with a cool black case, which makes it convenient to use in teaching and testing.
Adjustable trigger level: Available rising or falling edge trigger, and with instructions.