Altronix ACMB Series Access Power Controller with 8 PTC Outputs Power Supply, 12/24 VDC, 6 Amps (Pack of 1)

Price: $219.97
Product prices and availability are accurate as of 2019-03-18 18:20:06 UTC and are subject to change. Any price and availability information displayed on http://www.amazon.com/ at the time of purchase will apply to the purchase of this product.
Availability: In Stock
Usually ships in 1-2 business days
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Manufacturer Description

Altronix 8 PTC outputs power supply/access power controller converts a 115V AC 60Hz input into 8 independently controlled 12V DC or 24V DC Fail-Safe and/or Fail-Secure outputs with a total of 6 amp continuous supply current. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an access control system, card reader, keypad, push button, PIR, etc. This unit will route power to a variety of access control hardware devices including mag locks, electric strikes, magnetic door holders, etc. The outputs will operate in both Fail-Safe and/or Fail-Secure modes. This unit is designed to be powered by one common power source (factory installed) which will provide power for both the board operation and locking devices, or 2 totally independent power sources, 1 providing power for board operation and the other for lock/accessory power. The FACP Interface enables emergency egress, alarm monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the 8 outputs. Input: Input 115V AC 60Hz rated at 3.5 amp. Output: 12V DC or 24V DC at 6 amp supply current. Class 2 Rated power limited outputs. Output ratings: PTCs are rated at 2.5 amp. Filtered and electronically regulated outputs (built-in power supply). Fire alarm disconnect input options: Normally open (NO) or normally closed (NC) dry contact input. Polarity reversal input from FACP signaling circuit. Built-in charger for sealed lead acid or gel type batteries. Zero voltage drop when unit switches over to battery backup (AC failure condition). ACM8CB board main fuse is rated at 10 amp. Wall mount enclosure for indoor use. Accommodates up to 2 12V DC/12AH batteries. Measures 12-1/4-inches width by 15-1/2-inches height by 4-1/2-inches depth. 1.125-inches and 1.375-inches combination knockouts. UL listed, CSFM - California State Fire Marshal Approved, MEA - NYC Department of Buildings Approved.

Product Features

Fire alarm disconnect (latching or non-latching) is individually selectable for any or all of the 8 outputs Alarm output relay indicates that FACP input is triggered (form "C" contact rated at 1 amp 28V DC) Short circuit and thermal overload protection AC fail supervision (form "C" contact) Lifetime warranty